I\u2019m on \u201cice watch\u201d in Hammerfest, Norway, sitting here on my sailboat Phywave. My route through the Russian Arctic is currently blocked but uncharacteristically extensive, stubborn ice in the Vilkitsky Strait (shown by that big patch of red in the strait). The NSR guys I\u2019m working with don\u2019t have a forecast date for when it will open up, so until then, I\u2019m biding my time in Hammerfest.<\/p>\n\n\n\n
After a catastrophic failure of my compass and associated autopilot failure that forced me to retreat to Iceland to figure it out, the voyage from Husavik to Hammerfest went pretty smoothly with the compass and autopliot performing well. <\/p>\n\n\n\n
As always, the weather was a challenge with one particularly large low pressure system I had to navigate around to the south before turning back north again. The southerly winds were so fierce, 30 – 40 kts, when I arrived in the Hammerfest channel in the middle of the night, that instead of trying to enter the harbor and marina then, I decided to heave-to out in the channel until the winds weakened several hours later. At around noon on Saturday, August 1, I was finally able to get in and tie up in the small 8 berth marina they have which is literally right in the center of town with many nearby restaurants and shops. After making a phone call to arrange to meet someone to complete entry formalities at the police station, which is normally closed on weekends(!), I reviewed my tasks list while having lunch across the street.<\/p>\n\n\n\n
One thing I haven\u2019t mentioned before is the screwed up whisker pole I use to wing out my genoa headsail when sailing downwind. One end of the pole is attached to a bracket called a mast car that slides up and down a T-track bolted to the front of the mast. When normally stowed, the pole is vertical in front of the mast. To deploy it, I pull the bottom end of the pole forward until it\u2019s more or less horizontal and then attach it to the clew of the genoa. When I do this, the top end of the pole with the car slides down the track. The mast car is supposed to have plastic inserts that let it slide smoothly along the track. At some point, I don\u2019t really know when, those inserts fell out or were worn away so that there was metal on metal as the car slid on the track. Worse, without the plastic inserts, the car was too loose on the track and would fall off so the rig fundamentally was not working. The only fix was to get replacement plastic inserts, about $25 a pair, but $250 for express shipping to Norway, to Vard\u00f8 in this case. <\/p>\n\n\n\n
Which brings up my conundrum when I changed my Norway destination from Vard\u00f8 to Hammerfest. In addition to whisker pole car inserts, I had a couple of other things shipped to Vard\u00f8, including a new Spade S140 anchor coming from France. As I mentioned in a previous post, I had serious problems with the Rocna Vulcan anchor hanging so low in rough seas, catching waves, and yanking on the windlass. I finally got so disgusted with it, I decided to replace it with a new Spade anchor, an S140 30 kg model, one size bigger than 25 kg model I had before on my solo 7 continents circumnavigation voyage. But at the time I ordered it I still had Vard\u00f8 as my Norway destination so had it shipped there. <\/p>\n\n\n\n
There are direct flights from Hammerfest to Vads\u00f8, an hour\u2019s drive from Vard\u00f8, but you don\u2019t bring a 30 kg anchor (in two heavy packed boxes – fluke and shank) as checked luggage on the small commuter plane making that run. The alternative was to rent a car and drive to Vard\u00f8 to get it, which I did, 7 hours each way across the roads of northern Norway threaded around fjords and across windswept, treeless, highlands. Anybody who knows me knows I\u2019m steely-eyed endurance driving fool but even that was a lot for me – to Vard\u00f8 on Monday, back to Hammerfest on Tuesday. I had a nice night at the Vard\u00f8 hotel (the only hotel) and a delicious dinner – their dish named \u201cCod is Great\u201d. <\/p>\n\n\n\n
After I saw Vard\u00f8, I was immensely glad I changed to Hammerfest as my jumping off point for the Russian Arctic, a choice I should have made in the first place if I\u2019d done more effective research. Vard\u00f8 is a sad, dilapidated little fishing village with one hotel (a few guest houses as well) three or four small restaurants with limited hours, and a fishing fleet. The thought of Phywave being in a berth on the bouncing dock along with the fishing boats, with a long walk to the very few places in the town like the grocery store, was a really depressing thought, especially compared to where Phywave is in Hammerfest. Even the fuel dock in Vard\u00f8 was a rundown set up. It didn\u2019t help that the wind was blowing 30 kts with driving rain when I arrived – a terrible first impression. Well, at least I got good at typing the \u201co\u201d with the line through it. Just hold your finger down on the \u201co\u201d and a bunch of alternatives will appear you can choose from.<\/p>\n\n\n\n
So Hammerfest. I fixed the whisker pole, installed the new Spade anchor (I\u2019ll probably unceremoniously dump the Vulcan at sea), and am now thinking about installing a Furuno SCX-20 GPS compass which is staring at me from a box on the galley counter. After the fiasco with my compass in Iceland, several experienced high latitude sailors said to get a GPS compass. A GPS compass uses an array of GPS antennas to establish direction so it\u2019s immune to magnetic or electrical interference, but like any GPS system, needs a reasonably clear view of the sky. Until now, I didn\u2019t even know GPS compasses existed. Another failure on my part in my inadequate preparations for this voyage which have become apparent in a number of ways.<\/p>\n\n\n\n
The Navico dealer in Iceland connected me with a dealer in Norway who, extraordinarily, was able to find this compass in stock and have it shipped overnight to me in Hammerfest. It plugs right into the NMEA2000 backbone network and should show up along with the Precision 9 compass as a source I can select for heading information. I\u2019m not sure how and where I\u2019m going to mount it. It\u2019s a waiting-on-ice project.<\/p>\n\n\n\n I\u2019m on \u201cice watch\u201d in Hammerfest, Norway, sitting here on my sailboat Phywave. My route through the Russian Arctic is currently blocked but uncharacteristically extensive, stubborn ice in the Vilkitsky Strait (shown by that big patch of red in the strait). The NSR guys I\u2019m working with don\u2019t have a forecast date for when it will open … Continue reading Hammerfest, Norway<\/span> ![\"\"](\"https:\/\/www.phywave.com\/wp-content\/uploads\/2026\/08\/Arctic-Circumnavigation-Map-260805-1024x854.jpg\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/www.phywave.com\/wp-content\/uploads\/2026\/08\/Russias-Ice-chart-260804-768x1024.jpg\")
<\/figure>\n","protected":false},"excerpt":{"rendered":"